Pay attention to the operation of the gearbox. The rock drill should be idling for about one minute. To prevent such a situation, the hammer drill has been added with the “impact blocking” function, designed for drilling various holes in wood or metal.īefore the actual operation of the tool, it is necessary to check the mode in which it is located. When using drill chucks, do not use the counterclockwise and impact drilling positions, as this could damage the chuck and cause it to separate from the power tool. When drilling, you do not need to press hard on the drill, the pressure on it should not be more than five kilograms. After that, you need to place the drill in the right place and turn on the tool using the button. The toggle switch is installed opposite the mark, which looks like a drill. The tool must first be switched to drilling mode without impact. When you can “make noise” with a puncher.
Techniques for working correctly with a punch.
#Milwaukee hammer drill stopped working how to
How to work with a punch in different modes.In order not to lose control of the tool, you need to consider this possibility even before starting work and immediately take a comfortable position, securely holding the drill. When drilling in concrete, the drill bit may bump into the reinforcement. When filling the hole with crumbs and dust, try to empty the drill out to clear the debris. The hammer drill must be held firmly, but do not put pressure on it. After that, the drill must be positioned where it is necessary to make a hole, and then turn on the tool.ĭuring drilling, you need to try not to skew the drill, not allowing it to slide from the desired point. In this case, the toggle switch is installed above the mark with the image of the drill and hammer. Impact drilling mode (drilling)įirst you need to switch the hammer drill to hammer drilling mode. It is worth considering that the motor and shaft are located vertically. This procedure is no different from repairing a conventional rock drill. It is enough to tighten it or replace it. Unscrew the model and make diagnostics, change the lubricant if necessary.
Leakage is a direct indicator of wear on certain parts inside the mechanism.
0 kommentar(er)
